Measurements—Key Exercises

Basic Data Setup

Purpose: The purpose of this exercise is to show you how to set up the object level that will be used for measurements on an equipment object. Once equipment object information is defined, object levels are associated with objects to represent their actual hierarchical position in the structure.

Windows:
Equipment Basic Data/Object Levels

Object Level

  1. Create a new object level that allows serial objects to be connected to it.

General exercises for Object Level

Main Exercises

Purpose: The purpose of these exercises is to show you how to enter measurement information that you need when working with equipment objects.

Windows:
Functional Object
Measurements
Equipment Object Navigator

General Information

Note: If you have completed the Object Information—Key Exercises, you can skip this exercise and continue with the Test Points and Parameters exercise below. 

  1. Open the Equipment Object Navigator window and query for the functional object PM-312-PA-101 Pulp Pump 1.
  2. Select the PM-312-PA-101 Pulp Pump 1 object in the tree view.
  3. See that this object can be viewed as Selected Object in the Summary tab to the right.
  4. Select the Functional Object tab.
  5. Click the General tab.
  6. Use the List of Values to select APP20-300 as the type designation and 100 Pumps as the object type for the Pumps, if this has not already been done.
  7. Enter 13 Mechanical as the category and 50 paper machine 1 as the group ID.
  8. Enter the room/position description.
  9. Select an appropriate cost center using the List of Values.
  10. Specify that this Pump is manufactured by GE General Electric and supplied by ABB Automation AB.
  11. Save your changes (F12). 

Test Points and Parameters

Note: IFS Racing focuses on preventive maintenance. Management has decided to monitor your PM-312-PA-101 Pulp Pump 1. It is your job to enter the appropriate test points and parameters. 

  1. Open the Functional Object window, and click the Testpoints/Parameters tab.
  2. Enter an optional test point and description. Specify where this test point on the equipment object is located.
  3. If you enter test point values on this tab, you can link them to parameters. In this case, vibration parameter will be used as the criterion for generating work orders. 

Note: New parameters are entered in the Maintenance Basic Data window.

  1. You can specify whether a parameter will be used as a criterion in IFS/Preventive Maintenance (PM). If Yes is selected in the Criterion field, the criteria must be defined for separate or route PM action.