Use this tab to enter the type of instruction that is to be performed on the selected modification. The following table shows the valid modification execution type for which an instruction can be defined:
| Modification Execution Type | Description |
| Initial inspections | The instructions for performing the initial inspection. Before the status of the modification is set to Active, define the intervals for the performance of the initial inspections in the Define Modification/Execution/Initial Inspections tab. |
| Continued inspections | The instructions for performing the continued inspection. Before the status of the modification is set to Active, define the intervals for the performance of the continued inspections in the Define Modification/Execution/Continued Inspections tab. |
| Terminating Action | The instructions for performing the actual modification (i.e., when complying or embodying the modification). If you have selected a value in the Next Interval Maintenance field or selected the Next Visit In Workshop check box in the Define Modification/Assign Parts tab, you do not need to define intervals for the terminating action. However, if the Next Interval Maintenance field does not have a value entered or the Next Visit In Workshop check box is not selected, you are required to define the intervals for performing the terminating action before setting the status to Active. |
| Decomply | The instructions for reversing the modification. This option is available only if the Decompliance Allowed check box is selected for the part number in the Define Modification/Assign Parts tab. |
For the description of each tab in the window, follow the appropriate link: Operations, Material Usage, Tools and Facilities, Subtasks, Sequencing, Sign Off Req..
Define where Instructions should be used