Use this tab to enter and view information on the parameters needed to enter measurements on a functional or serial object. To be able to take measurements and trigger preventive maintenance generation, a parameter must be defined and connected to the object. You can also define parameters that are used for generating condition-based preventive maintenance actions. Also use this tab to enter and view information on test points on the object. The test points defined for an object are those of particular interest for measurement, for example, bearings for a pump or welds on a tank. The test points can be used when preventive maintenance actions are created for the object. The test points can be included in a work order that is created for the object.
Note: By default a Testpoint ID (*) is available. Use this default test point id to register parameters on the Object, or create new test points if needed.
Define
Serial Object
Define
Functional Structure
Define
Parameters for Condition Based WO Generation
Enter
Test Point
Enter
Parameter