Release Disposition Shop Order Line - Component MRO
Explanation
This activity is used to release a disposition shop order
line. The release of a disposition shop order line indicates that the disposition process
is completed. This means that all disposition operations have been performed for the parts
recorded and identified for the disposition line.
Once the line is released, you
can continue the repair process by recording discrepancies detected during the
disposition process and selecting the appropriate repair codes for
the elimination of the discrepancies. At release, the parts will be received into inventory and reserved for approval, i.e., the
parts will be reserved in inventory and the reservation will be inherited by
either the MRO shop order or the external service order created for the
executing the repair.
A released disposition shop order line can be reversed by un-releasing.
Prerequisites
- This activity requires the existence of a disposition line on a disposition
shop order in the state New.
- The repair part should be registered and identified
for the disposition shop order line.
- The repair part and the consumables needed for the
processing of the disposition must be issued.
- All operations associated with the disposition shop
order line must be reported.
System Effects
As a result of this activity:
- The status of a disposition shop order line will be updated to Released.
- If the disposition code indicates that the material is
to be scrapped, the scrap transaction will occur. Otherwise, the material will be received into
inventory and reserved for approval.
- If the material is scrapped, the task will be removed from the work scope
if it was not approved. If the task had a status of Approved, the
status will be updated to Removed.
- If the scrapped material is an assigned part for a modification, all its
affected component parts in work scope will be deleted. If the the
scrapped material is an affected part for a modification, it will be deleted
from the work scope.
- The task in IFS/Vehicle Information Management is canceled.
- The vehicle condition of the serial is set to the vehicle condition code
defined with the setting Set when last task is finished. For more
information see Define
Vehicle Condition.
Window
Disposition
Shop Order
Related Window Descriptions
Disposition Shop Order
Procedure
To release a disposition shop order line:
- Select one or more lines in the the table section of the
Disposition
Shop Order window
header.
- Right-click and then click Release.
To un-release a disposition shop order line:
- Select one or more lines in the the table section of the
Disposition
Shop Order window
header.
- Right-click and then click Un-release.